MSEFI fuel injection system for the Vmax

Image

Bought at EBay a GSXR 1000 throttlebody kit.
These injectors are enough to feed till a maximum of 300 HP at highest pressure rate.
I am going to use the Megasquirt DIY computer.
Image

Pre machined parts for a manifold.
Made them at my dads garage where he has a Lathe and a milling machine. He is black smith for his hobby.
Image

Again soldered with Alutite. Did the Keihin FCR manifolds also with them.Was a very good lesson to make and these ones also with the Alutite done.
Image

Lot of Dremel work to get all shapes inside as needed. The outside where the raw Alutite was is also sanded of and later polished the outside.
Image

The test setup and the polished manifolds.  
Top view of the 42 mm throttle bodies.
Image

Now making the connection between the 2 sides and making the fuel rail.
Image
Wiring everything on the bike.
Image

Topview. Everything mounted and fixed.
Cleaned up the wiringmess and connected the NOS kit.
Mounted a fuelpressureswitch for the NOS kit as safety for the possible fuelpressure drop. Also a set of chrome top K&N filters mounted for street use.
Image

Clear Fuel lines for the NOS kit on the bottom and above them the injectors from the MSEFI controller.
Image

It runs !!!! Not that well but have to tune everything.
The wbo2 controller from TechEdge works well. and the Megasquirt a little changed also.

Share this page on:

Submit to DeliciousSubmit to DiggSubmit to FacebookSubmit to Google PlusSubmit to Stumbleupon Submit to TwitterSubmit to LinkedIn

Site related on the net:

GoogleplusGoogleYoutubePaypal